Install Instructions

Page 37
NEOTHERM Residential Boilers
HIGH EFFICIENCY RESIDENTIAL BOILERS
®
Figure 28. - Quick Start Menu
Changing the CH (Central Heat) Setpoint -
Figure 29. - Changing the CH Setpoint
• On the Quick Start menu, use the Up- and Down-
Arrows to go to the line for CH Setpoint. Press the
large OK button to select the line.
• Use the Up- and Down-Arrow buttons to select the
value you want.
• Press the round OK button to enter the new value.
Changing the DHW (Domestic Hot Water) Setpoint -
See the procedure described above for the CH setpoint.
Changing a Value Using a “Slider”
There is another type of control screen that you may see.
This type of screen uses a “slider” to set the value. This
system is used on the LCD Contrast screen (available
under Display Setup.) See “Figure 27. – Changing LCD
Contrast”.
Figure 27. – Changing LCD Contrast
• Use the Left- and Right-Arrow buttons to move the bar
and adjust the contrast.
• When the setting is correct, press the round OK button.
8.F Quick Start