User Guide

80
Service Manual NeoTherm 80 - NeoTherm 285
 Ontherightsideofthecontroller(readingtoptobottom):
 • DisconnectconnectorCP6fromJ6
 • DisconnectconnectorCP5fromJ5
 • DisconnectconnectorCP4AfromJ4(upperpart)
 • DisconnectconnectorCP4BfromJ4(lowerpart)
 Atthelowercenterofthecontroller:
 • Disconnectthelargeorangesparkcable
5. Nowyoucanremovethecontrolleritself.Thecontrollerisattached
tothesupportplatebyfourclips.Toremovethecontrol,pushthe
lowerendsoftheleftsideclips,andswingtheleftsideofthecontrol
towardyou.
Greenconnectormountedin
farrightposition
J2J1
CP10/J10
CP9/J9
CP8A/J8
CP8B/J8
J6/CP6
J5/CP5
J4/CP4A
J4/CP4B
Sparkcable
Removing and Replacing
the SOLA Controller (continued)
Fig. D9-2 - Connectors on the SOLA controller
6. Mountthenewcontrollerusing
thefourclips.
7. Replacethewiresandcables
listedabove.Thecablesand
connectorsarealllabeled.
8. Replacethefrontcoverand
turn on the power to the unit.
9. Youmayneedtoresetthecon-
troloninitialstartup.Pressthe
“OK”buttontoresetthecontrol.
D9
cont.