User Guide

71
Service Manual NeoTherm 80 - NeoTherm 285
Home Display
Whentheboilerisoperatingnormally,thecontrollerwill
displaytheHomedisplay.SeeFig.D5-2.
Thescreendisplayareahasthreesections:
• Theuppersectionofthisscreendisplaysthemost
importantoperatinginformationfortheunit.Inthe
exampleshownhere,thedisplayisshowingthesys-
temsetpoint,theoperatingtemperature,theoutlet
andinlettemperaturesforthewaterenteringand
leavingtheboiler,andtheoutdoortemperature.
 (Notethatthevelinesatthetopofthescreenare
customizable,andmaybearrangeddifferentlyon
your system.)
• Thecentralsectionshowssomeadditionaloperating
andsetupinformation.Inthiscase,thisarealists
theboilername,boilerstate,currentdemand,and
thecurrentpasswordlevel(the“accessstatus”).
• Thelowersectionshowsanycurrentlockouts,holds,
or alerts.
Info/Install Display
FromtheHomedisplayshowninFig.D5-2,pressthe“I”
button(“Info/Install”).Thedisplaywillchangetoshow
thesixsub-menusavailable.SeeFig.D5-3.
• Tomovefromonechoicetoanother,usetheLeft-
andRight-ArrowbuttonsortheUp-andDown-Arrow
buttons.
• Onceyouhavehighlightedthechoiceyouwant,
presstheroundOKbutton.
TableD5-2showsthefunctionslistedundereachofthe
sub-menus.
Fig. D5-2 - Home display
Fig. D5-3 - Info/ install display
Using the Current User Interface - continued
D5
cont.