User Guide

Service Manual NeoTherm 80 - NeoTherm 285

Removing and Replacing

the Original (White) User Interface

PleasecheckthetroubleshootinginstructionsinSectionAbeforereplacingtheuser

interface.Hereistheremoval/replacementprocedure:

1. TurnoffallpowertotheNeoThermunit,andshutoffallmanualgasvalves.

2. RemovethefrontdoorontheNeoTherm,andremovetheplasticbezelfromthe

control panel.

3. Disconnectallofthewiringconnectionstothecontrolmodule.(Theconnectors

arekeyedsothattheycanonlybeinsertedoneway.Becarefulnottobendthe

wiressharplyorpullthemoutoftheconnectors.)

4. Toremovetheuserinterface,pushinonthetwotabsontheleftsideoftheboard

tounlatchtheclipsfromthecontrolpanel.Rotatetheboardaroundthefastening

pointsontherightsidetoseparatethehooksfromtheboard.

5. Toreplacethepart,repeatthestepslistedaboveinthereverseorder.Besureto

re-connectallofthewiringconnectorsintheirproperlocations.