User Guide

65
Service Manual NeoTherm 80 - NeoTherm 285
Identifying the User Interface on Your Unit
There are two main parts to the control system on a
NeoTherm unit:
• The“controller”-Thisisthecontrolmodulethat
contains the computer that actually operates the
unit.Thecontrollerislocatedinsidethecabinetof
the unit.
• The“userinterface”-Thisisthecontrolpanelthat
allowstheoperatortochangecontrolsettingsand
getreadingsfromtheunit.Theuserinterfaceis
mountedonthefrontoftheunit.
NeoThermunitshavebeenproducedwithtwodifferent
typesofuserinterfaces,asshownbelow.Noticethat
Laarshasbeenusingthesamecontrol module through-
out(theSOLAcontroller),buttheuser interfaces were
changedin2012.(Therewereactuallytwoversionsof
thecurrentuserinterface,issuedbeforeandafterOcto-
ber2012.Thereareslightdifferencesinthewaythese
two versions operate.)
Thetypeofinterfaceusedonyourunitwillaffecttheway
younavigatebetweenthedifferentcontrolfunctions.In
thefollowingsections,wewillincludequicksummaries
oftheinstructionsforthetwotypesofinterfaces.
Fig. D1-1
Original (“white”) user interface -
2012 and earlier
Fig. D1-2
Current user interface -
production after 2012
D1