Install Instructions

Page 35
NEOTHERM Residential Boilers
Figure 28. -QuickStartMenu
ChangingtheCH(CentralHeat)Setpoint-
Figure 29. -ChangingtheCHSetpoint
• On the Quick Start menu, use the Up- and Down-Arrows
to go to the line for CH Setpoint. Press the large OK
button to select the line.
• Use the Up- and Down-Arrow buttons to select the value
you want.
• Press the round OK button to enter the new value.
ChangingtheDHW(DomesticHotWater)Setpoint-
See the procedure described above for the CH setpoint.
ChangingaValueUsinga“Slider”
There is another type of control screen you may see. This
type of screen uses a “slider” to set the value. This system
is used on the LCD Contrast screen (available under Display
Setup.) See Fig. 33.
Figure 26. –ChangingLCDContrast
• Use the Left- and Right-Arrow buttons to move the bar
and adjust the contrast.
• When the setting is correct, press the round OK button.
8.6 QuickStart