Instruction Manual

Page 5
Mascot II
Step 3 SET UP MODE Note: You do not need to press DONE after each adjustment in this mode. Wait until all changes are made , then press DONE. • From the outlet screen, press and hold the UP and Down arrows together for 5 seconds. (You must press the up/down arrows at the same time for 5 seconds). • The Fahrenheit symbol will now appear on the display. You are now in SET UP MODE.
Press the NEXT button to advance to the next screen.
• This screen is used for outdoor reset. It is defaulted to OFF. If you are not using the
outdoor reset function, then leave this screen OFF, press NEXT and proceed to page,
Under RMT address.
• If you are using out door reset, press the up arrow and turn this feature ON. To use this feature, you must install the OUTDOOR SENSOR. Note: When you turn on outdoor reset, three more parameters will be added to
the menu. Those screens will be LBT, HOD, LOD. Once these parameters are set, the boiler control will configure your reset curve .
Page 5