Manualshelf

Instruction Manual

ManualsBrandsLAARS ManualsWater boilerMascot llLMC - Start Up Guide
12345678910
Page 1
Mascot II
MASCOT II START UP GUIDE
IMPORTANT:
Before powering up the boiler, turn off the call for heat and hot
water. If needed, disconnect the thermostat wire from terminal 2.
Turn on power to the boiler.
The system display will flash a code of 3.6. for 90 seconds.
During this time, no set points or adjustments can be made.
Note; any time the power is turned off to the boiler and then
restored, the flash code will appear for a 90 second period.
After 90 seconds, the 3.6 flash code will time out and
the display will then show the Outlet screen.
The word Outlet will appear in the top left corner of the display
screen.
Page 1