Instructions / Assembly

Assembly Steps:
Note: Do not fully tighten bolts until product is completely assembled.
Step 1. Carefully place the table rim (A) upside down on a non-abrasive surface. See Figure 1.
Step 2. Assemble the table legs (D) to the table rim (A) with bolts (E) and washers (F) by using allen wrench (H).
as shown in figure 1.
Figure 1
Step 3. Assembly the leg connector (B) to the table legs (D) with bolts (E) and washers (F) by using allen wrench (H). See
Figure 2.
Step 4. Check the alignment of all table legs (D) and adjust if necessary. Once the alignment is correct, tighten all bolts with
allen Wrench (H).
Figure 2
Step 5. Cover all bolts with plastic caps (G). See Figure 1-2.
A