Installation Guide

La Crosse Technology, Ltd Page 4
 This is indicative of a low or overpowered battery (number 1 warranty issue).
 Replace battery and perform restart procedure. Allow 5 days to catch the WWVB signal
 If constant spinning continues, the movement may need replacement.
HANDS JUMPS OR JERKS AROUND THE DIAL
 This is indicative of a low or overpowered battery (number 1 warranty issue).
 Replace battery and perform the restart procedure
. Allow up to 5 days to receive a
signal.
 If the hands continue to jump, the movement may need replacement.
HANDS STUCK AT CERTAIN TIME
 This is indicative of a low or overpowered battery (number 1 warranty issue).
 Replace battery and perform restart procedure. Allow up to 5 days to receive a signal.
 Check to see if the hands may be bent.
 Movement may need replacement.
HANDS ARE LOOSE.
 If under warranty, the clock must be sent in for repair or the movement needs to be
replaced.
POSITION THE CLOCK
 This La Crosse Technology
®
atomic clock is designed for indoor or outdoor use.
 INDOOR: Select a location to place the radio-controlled clock where it will be at least
six feet away from a TV, computer, air conditioner or other household electrical
appliances. The optimal location is near a window. Windows facing Colorado provide the
best signal.
 OUTDOOR: Select a location sheltered from direct sunlight and rain, preferably under
a roof or porch area, and facing Colorado for better reception of the WWVB signal.
 This clock is designed for indoor and outdoor use: but only in a dry environment and in a
temperature range between -10°F and 131°F.
Note: The clock is NOT waterproof. If left in the elements water may enter the clock and
damage it.
HOW DO I ADJUST THE TEMPERATURE OR HUMIDITY?
 With a flat tipped screwdriver, gently turn the temperature or humidity sensor screw at
the back of the clock to the desired setting.