Instruction manual

50
Note: The MIN/MAX data for each transmitter needs to be reset separately.
TO VIEW THE MIN/MAX DATA FROM DIFFERENT TRANSMITTERS
When more than 1 transmitter used:
1. To toggle between transmitters, press the CH key:
Once to show transmitter 2
Twice to show transmitter 3
Three times to return to transmitter 1
2. Use OUT key to view the MIN/MAX temperature and humidity data for the selected transmitter.
3. To reset the minimum and maximum temperature and humidity data, and the times at which they were
recorded, press the SET key continuously for about 3 seconds. This will reset the MIN/MAX data recorded to
the current time, date, temperature and humidity. The current time taken is the normal displayed time and
does not regard the time zone set for the unit.
Note: the MIN/MAX data for each transmitter needs to be reset separately.
LOW BATTERY INDICATOR
Low battery indicator is displayed on the LCD when the batteries require changing.
THERMO-HYGRO OUTDOOR TRANSMITTER:
The temperature and humidity are measured and transmitted every 4 seconds.
The range of the Thermo-Hygro outdoor transmitter may be affected by the temperature. At cold temperatures the
transmitting distance may be decreased. Please bear this in mind when placing the transmitter.
868MHz RECEPTION CHECK
If the outdoor temperature and humidity data are not being received within three minutes after setting up (or
outdoor display always show “- -. -” in the outdoor section of the Weather station during normal operation), please
check the following points: