Instruction manual

49
OUTDOOR TEMPERATURE AND HUMIDITY:
The last LCD section shows the outdoor temperature and humidity, a reception signal and a number beside the
temperature will also show if more than one transmitter has been used.
TOGGLING AND RESETTING THE OUTDOOR RECORDINGS:
1. To toggle between the outdoor current, minimum and maximum temperature and humidity data and the
times at which they were recorded, press the OUT key:
Once to show the minimum temperature and humidity values with time and date recorded
Twice to show the maximum temperature and humidity values with time and date recorded
Three times to return to the current time, date, temperature and humidity levels
Note: the time/date information is only available for MIN/MAX temperature data.
2. To toggle between transmitters, press the CH key:
Once to show transmitter 2
Twice to show transmitter 3
Three times to return to transmitter 1
Note: The transmitter number will only be displayed if there is more than one transmitter detected.
3. To reset the minimum and maximum temperature and humidity data, and the times at which they were
recorded, press the OUT key continuously for about 3 seconds. This will reset all minimum and maximum
data recorded to the current time, date, temperature and humidity. The current time taken is the normal
displayed time and does not regard the time zone set for the unit.
Outdoor Reception Signal
Maximum Display
Outdoor
Temperature in °C
Relative Humidity %
Number showing Transmitter unit (only if there is more than one transmitter)