Instruction manual

To set the clock:

1. The hour and minute digits start flashing in the time display section.

2. Use the IN key to adjust the hours and the OUT key to adjust the minutes. If you hold the key while you

adjust, the hours move 1 hour and the minutes move 5 minutes.

3. Confirm with the SET key and enter the “Calendar Setting” or exit the setting mode by pressing the

Note:

The unit will still try and receive the signal despite it being manually set. When it does receive the signal, it will

change the manually set time into the received time. During reception attempts the DCF tower icon will flash. If

reception has been unsuccessful, then the DCF tower icon will not appear but reception will still be attempted the

following day.

CALENDAR SETTING

Year (flashing) Date (flashing) Month (flashing)

The date default of the Weather station is 1. 1. of the year 2006 after initial set-up. Once the radio-controlled time

signals are received, the date is automatically updated. However, if the signals are not received, the date can also

be set manually. To do this:

1. Using the IN key, set the year required. The range runs from 2003 to 2029 (default is 2006).

2. Press the SET key to enter the month and date setting mode.

Minutes (flashing)

Hours (flashing)