FAQ

La Crosse Technology, Ltd. Page 7
Daylight Saving Time
 Dependent on your location, position of the clock in your home, and atmospheric
interference, it may take up to 5 nights for the change from Daylight Savings Time to
Standard Time and vice-versa to occur.
 Check for a WWVB Tower Icon showing on your Clock. The tower icon indicates you have
received the WWVB signal from Ft Collins CO in the past 24-hours.
 Check that the clock is in the correct Time Zone.
 Check whether the DST indicator is ON or OFF. If the indicator is OFF the clock will not
change.
 Check for fresh batteries. Without proper batteries, the antenna will have a harder time
picking up the signal.
 Position the Clock in a window (with the front or back) facing Ft. Collins, Colorado and leave
for up to five nights. If you do not have a window facing this direction, locate the Clock near
an outside wall and point the unit in this general direction.
Is There a Booster Antenna
 No. There is not a booster antenna available for the WWVB time signal.
 There is not a signal booster available for the outdoor transmitter signal.
Can the Clock Attach to a Timer?
 No timer circuit can be attached to the clock. Modifications will void the warranty.
Set Time Alarm
 ALARM HOUR: Press and hold the ALARM button to enter alarm time setting mode. The
Alarm Hour will flash. Use the + or - button to set the Hour. Press and release the ALARM
button.
 ALARM MINUTE: The Alarm Minutes will flash. Use the + or - button to set the Minutes.
Press and release the ALARM button to exit.
Activate/Deactivate Time Alarm
ACTIVATE:
 Press and release the ALARM button to activate the alarm.
 The alarm icon (bell) appears when alarm is active.
DEACTIVATE:
 Press and release the ALARM button to deactivate the alarm.
 The alarm icon will disappear when alarm is deactivated.
Snooze Alarm
 When the alarm sounds, press the SNZ button to trigger snooze alarm for 5 minutes.
 The snooze icon Zz will flash when the snooze feature is active.
 To stop alarm for one day, press AL button, while in snooze mode.
 The alarm icon (bell) will remain solid.
Manually Set Time/Date: Program Menu
PROGRAM MENU:
There are four function keys located on the reverse of the unit: SET, + (PLUS), ALM, and SNZ.
Begin by holding the SET button until the display flashes. Press and release the PLUS button
to change a value. When you press and release the SET button after each step, you will move
to the next step.