FAQ

La Crosse Technology, Ltd. Page 4
 The outdoor temperature reading will flash when the connection is first lost or intermittent
between the clock and the outdoor transmitter.
 Check batteries.
Overpowered or underpowered batteries can cause this reading.
 Replace outdoor transmitter.
Outdoor Transmitter Fell and No Longer Works
 If there is no physical damage to the outdoor transmitter, the fall may not have caused
internal damage.
 An outdoor transmitter that has fallen into a puddle or other standing water or snow may
have water damage.
 Transmitters are water resistant, not waterproof.
 A fall can shock the transmitter or the batteries in the transmitter.
 Batteries that have fallen on a hard surface may be damaged and unable to function
properly.
 Complete a restart
with fresh batteries.
 Use batteries dated at least six years in advance of the current year.
Outdoor Transmitter Drains Batteries Quickly
 Test a new set of alkaline batteries. Write down the date of installation and the voltage of the
batteries.
 When the batteries fail, please note the date and voltage again. This is helpful in
determining the problem.
 Check the distance
and resistance between the transmitter and clock. Transmitters at the
end of the range may work while batteries are fresh but not after they drain a bit.
 Check for leaking batteries, which may damage the transmitter.
 Battery life is over 24 months when using reputable battery brands for both Alkaline and
Lithium batteries.
Mounting/Positioning Outdoor Transmitter
 Mount outdoor temperature transmitters vertically and under a bit of an overhang.
 Protect the outdoor transmitter from standing rain or snow, and from the overhead sun,
which can cause it to read incorrectly. Generally, mounting under an eave or deck rail works
well.
 Construct a small roof or box for the transmitter if you do not have an overhang. Please be
sure the box is vented.
 Mount the transmitter on the North side to prevent sun from causing incorrect readings.
 Mount at least 6 feet in the air for a strong signal.
 Outdoor transmitters are water resistant but not water proof.
 Avoid more than one wall between the transmitter and the Clock.
 Do not mount near electrical wires, transmitting antennas or other items that will interfere
with the signal.
 RF (radio frequency) signals do not travel well through moisture or dirt.
 Place the outdoor transmitter and the Clock in the desired shaded locations, and wait
approximately 1-hour before permanently mounting the transmitter to ensure that there is
proper reception.
 Do not mount the transmitter on a metal fence. This significantly reduces the effective range.
MOUNT
 Choose a location for the transmitter that is within range
of the clock and under an overhang
for accuracy.
 Install one mounting screw into a wall leaving approximately ½ inch (12.7mm) extended.