Instruction manual

Cable connection between

the

wind sensor and the

thermo

-hygro sensor

Cable connection between

the

rain sensor and the

thermo

-hygro sensor

Wireless transmission at

915 MHz - thermo-

hygro

sensor to the

Weather

Center

Weather Center

Wind Sensor

Rain Sensor

SETTING UP:

Note:

When putting the Weather Center into operation, it is important to perform in close

proximity (e.g. on a table) a complete wiring and set-up of the system. This step is

important to test all components for correct function before placing and mounting them

at their final destinations (See Positioning below)

1. Unwind the cables of the rain and the wind sensors. Connect the rain and the

wind sensors to the thermo-hygro sensor by plugging the connector heads of

the two sensors into the appropriate sockets of the thermo-hygro sensor.

2. First insert the batteries into the thermo-hygro sensor (see “How to install and

replace the batteries into the thermo-hygro sensor“ below).

3. Then insert the batteries into the Weather Center (see “How to install and

replace the batteries into the Weather Center” below). Once the batteries

are installed, all segments of the LCD will light up briefly and a short signal

tone will be heard. It will then display the time as 12:00, the date as 1.1.05, the

weather icons, and air pressure value. "- - -" will be shown for outdoor data.

4. Afterwards, the Weather Center will start receiving data from the sensor. The

outdoor temperature, humidity wind chill and wind speed should then be

Sockets for wind

and rain sensor

- Do Not Mix Old and New Batteries

- Do Not Mix Alkaline, Standard, or

Rechargeable Batteries