Instruction manual

50
reset all units (see Setting up above) otherwise transmission problems may
occur.
x During normal operation, after the outdoor display shows "- - -", the Weather
Center will change to receive the outdoor data every 15 minutes, until the data
is read again. Then the reception period will return to 4.5 seconds.
x The transmission frequency may be switching between 910, 915 and 920 MHz
to enable successful signal reception by the Weather Center.
x If no reception is possible despite the observation of these factors, all system
units have to be reset (see Setting up).
POSITIONING
Prior to permanently affixing any of the units, please ensure the following points are
considered:
x Cable lengths of the units meet with your distance requirements at the point of
fixing
x Signals from the sensors can be received by the base center at points of
mounting
La Crosse Technology Sensor Extension Cable
When you require additional cable length to mount your sensor, you can use La
Crosse Technology extension cable. The extension cable is 32 feet in length and
comes with the appropriate connecter attached. Please visit your local retailer or
www.greatbigoutlet.com to purchase.
Phone cables and connections have much more resistance than our extension cable
and are not recommended for use. Using phone cable/connection may damage your
sensors.
51
Note: Using extension cables will shorten battery life.
Warning: Never cut, splice, shorten or modify your sensor cables or extension cables.
Doing so may damage your sensors and will void your warranty.
Weather Center
The Weather Center has been designed to be hung onto wall or free standing with the
base stand.
To wall mount
Before wall mounting, please check that the outdoor temperature and humidity values
are received from the desired locations. To wall mount:
1. Fix a screw (not supplied) into the desired wall,
leaving the head extended out the by about 5mm.
2. Hang the Weather Center onto the screw. Remember
to ensure that it locks into place before releasing.