User's Manual

Mounting Instructions
Option 1:
•
Install one mounting screw into a
wall leaving some extended.
•
Place the transmitter onto the screw,
gently pull the transmitter down to
lock the screw into place.
Option 2:
•
Insert the mounting screw through
the front of the transmitter and into
the wall.
•
Tighten the screw to snug (do not
over tighten).
•
Mount the temperature/humidity sensor on
a north-facing wall or in any well shaded
location. Sun will make it read high.
•
Under an eave or deck rail is preferred.
•
Be sure the outdoor sensor is mounted
vertically to drain moisture.
•
Avoid mounting under a metal roof and use
stainless screws for best WWVB reception
and RCC transmition.
•
The maximum wireless transmission
range to the weather station is over
330 feet (100 meters) in open air, not
TX232TH-LCD Temperature/Humidity Sensor
•
For most accurate wind speed and rainfall
readings, mount the Multi-sensor in an
open area clear for 50 feet in all directions.
•
Mount with the solar panel facing south so
the wind direction is correct. See N, S, E W,
embossed on the top of the sensor.
•
Use the bubble level on the top of the
sensor to ensure it is level, for accurate
rainfall readings.
TX231RW Multi-sensor
Bubble
Level
328-2314 www.lacrossetechnology.com/support Page | 6