User's Manual

Setup Preparation
Welcome!
Here are some items needed to setup your station (not included):
1. Phillips head screwdriver for assembly.
2. Fresh Batteries: 5 (ve) AA alkaline or lithium batteries for
the sensors.
3 (three) AAA alkaline batteries for the
station (optional).
For best results:
• Remove weather station and sensors from the package and place
together on a table or bench, within easy reach.
• Place batteries and screwdriver within reach of setup location.
• Keep sensors and weather station 5-10 feet apart for the rst
15 minutes after installing batteries.
• Each sensor reads independently to the weather station. Before
permanently mounting sensors, place them in desired location for
1 hour to be sure there is a steady reading to the weather station.
• Maximum transmission range is 330 ft. (100 m) open air.
• If sensor connection is lost, search for the sensors.
Search for Temperature/Humidity Sensor
• Hold the TEMP button for 2 seconds to search for the sensor.
• The tower icon will ash for 3 minutes indicating the search.
Search for Multi-sensor
• Hold the WIND button for two seconds.
• The tower icon will ash for 3 minutes indicating the search.
328-2314 www.lacrossetechnology.com/support Page | 2