User's Manual

Replace Directional Vane
1. Loosen the screw on side of vane
2. Remove direction vane
3. Install new vane
4. Tighten screw
Note: The directional vane attached to the stem on the sensor.
The screw will tighten to the at side of the stem for a
secure t.
Replace Wind Cups
1. Loosen the screw on side of cups
2. Remove cups
3. Install new cups
4. Tighten screw
Note: The screw in the wind cups will t on the at side of the
metal stem on the sensor.
Page | 23 www.lacrossetechnology.com/support 328-2314