FAQ
La Crosse Technology, Ltd Page 6
USB Output: Up to 3 Amps total if both ports are used
• Charge devices that self-regulate.
• Do not charge multiple devices from the same USB port.
• Must operate clock with power cable to charge other devices.
• Plug your device into one of the USB ports on the front of the clock.
• The clock will show HELLO for 3 seconds.
• The lightning bolt will flash while charging.
• When battery is full and minimal power is drawn, a solid battery icon is displayed.
• When no device is connected, no battery will show.
Will not Charge my iPhone
Insert the charge cord one-way, then if not charging, insert the other way.
The lightning connector may be directional.
NAP Feature
Sometimes, we just want a quick nap without having to set a new alarm. Set the
nap duration one time, then, a simple press of the NAP button starts the nap
countdown.
Set Nap Duration:
1. Hold the NAP button for 3 seconds. NAP and the duration will show (default is 10
minutes).
2. Use the +/- buttons to select a nap duration, up to 120 minutes.
3. Press the NAP button to confirm and start nap count down to zero.
Note: Set NAP once then just press NAP button to activate anytime.
When you wish to nap: Press the NAP button once, and the clock will wake you at
the preselected time.
From normal time display, press the NAP button once to start the nap feature
for the preset time. NAP will show and the preset minutes will countdown.
When the alarm sounds NAP and 00m will flash. The alarm will sound for two
minutes and then stop if no buttons are pressed.
Press any button at any time to exit nap mode.
Alarm Clock is dim
Press and release the SNOOZE/LIGHT button to determine if the backlight is on
HIGH or LOW.
Clock must operate on AC power for backlight to stay on.
Alarm Clock is blank: No letters, numbers or dashed lines
Check that the AC adapter. Is it correctly installed and connects to an active
outlet.
Batteries
may be overpowered or underpowered. Remove batteries from alarm
clock.
Press any button 20 times. Leave the alarm clock unpowered for 1-2 hours.
Power clock with AC adapter only to determine if batteries were an issue.