WT-5350 Radio Controlled Projection Alarm Instruction Manual R A D I O C O N T R O L L E D FCC ID: OMO-01RX (receiver) DATE THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: AL/SEL 1. THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND 2. THIS DEVICE MUST ACCEPT INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
TABLE OF CONTENTS Topic Inventory of Contents About WWVB Quick Set-Up Guide Detailed Set-Up Guide Battery Installation Program Mode Programming Sequence Function Buttons Time Zone Setting Time Setting Date Setting 12/24-Hour Mode DST (Daylight Saving Time) Setting GB P.2 INVENTORY OF CONTENTS 1) WT-5350 Alarm Clock 2) AC adapter/transformer 3) Instruction manual and warranty card. ADDITIONAL EQUIPMENT (not included) 1) Two fresh 1.5V AA batteries (optional for alarm clock) FEATURES OF PROJECTION ALARM 1.
a tone will sound for every second. It is possible that your Projection Alarm may not be exactly on the second due to the variance in the quartz. However, the clock will adjust the quartz timing over the course of several days to be very accurate; under . 10 seconds per day. QUICK SET-UP GUIDE 1) Insert two AA batteries into the Projection alarm and/or plug into wall 2) Wait 10 minutes for WWVB reception. 3) If there is no WWVB reception, manually set the time and date (instructions in the Program Mode).
A. B. FUNCTION BUTTONS There are 5 function buttons located on the front of the Projection Alarm. The function buttons are labeled: AL, light intensity icon, light direction icon, MODE/+, and SNOOZE (the top bar). PROGRAMMING SEQUENCE 1. Time Zone Setting 2. Hour Setting 3. Minute Setting 4. Year Setting 5. Month Setting 6. Day Setting 7. 12/24-hour Mode 8. Daylight Saving Time On/Off R A D I O C. TIME ZONE SETTING 1.
1. Hold down the "MODE/+" button for 2 seconds (the selected time zone will flash), press the "AL" button three times until the year flashes. 2. Press the "MODE/+" button to select the year. 3. Press the "AL" button to confirm the year and move to the month setting. 4. Press the "MODE/+" button to select the month. 5. Press the "AL" button to confirm the month and move to the day setting. 6. Press the "MODE/+" button to select the day. 7.
7. For more detail visit http://www.boulder.nist.gov/timefreq.htm. To listen to the NIST time call (303) 499-7111. This number will connect you to an automated time, announced at the top of the minute in "Coordinated Universal Time", which is also known as Greenwich Mean Time (GMT). This time does not follow Daylight Saving Time changes. After the top of the minute a tone will sound for every second. 8.
3. TURNING ALARM OFF (WHILE SOUNDING) Note: The alarm will sound for 23 seconds and then increase in volume and speed for another 62 seconds (85 seconds total). If no button is pushed it will shut off and be active for the next day. a. While the alarm is sounding, press the "SNOOZE" bar to disable the alarm for six minutes. b. After the "SNOOZE" bar is pressed, the alarm icon will flash in the lower left area of the display. c.
WARRANTY INFORMATION La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to the original purchaser of this product. To receive warranty service, the purchaser must contact La Crosse Technology, Ltd for problem determination and service procedures.
