User's Manual

1. Remove the battery cover.

2. Insert the batteries, observing the

correct polarity (see battery

compartment marking).

3. Replace the battery cover on the unit.

Note:

In the event of changing batteries in any of

the units, all units need to be reset by

following the setting up procedures. This is

due to a random security code assigned by

the transmitter at start-up. This code must be received and

stored by the weather station in the first 3 minutes of

power being supplied to the transmitter.

BATTERY CHANGE:

It is recommended to replace the batteries in all units on

an annual basis to ensure optimum accuracy of these

units.

Please participate in the preservation of

the environment. Return used batteries to

an authorized depot.

SETTING UP

1. First, insert the batteries in the transmitter (see “To

install and replace batteries in the thermo-hygro

transmitter” above).

2. Within 2 minutes of powering up the transmitter,

insert the batteries in the Temperature Station (see

“To install and replace batteries in the weather

station” above). Once the batteries are in place, all

segments of the LCD will light up briefly. Following

the indoor temperature/humidity and the time as

12:00 will be displayed. If these information are not

displayed on the LCD after 60 seconds, remove the

batteries and wait for at least 60 seconds before

reinserting them. Once the indoor data is displayed

user may proceed to the next step.

3. After the batteries are inserted, the weather station

will start receiving data signal from the transmitter.

The outdoor temperature and humidity data should

then be displayed on the weather station. If this

does not happen after 2 minutes, the batteries will

need to be removed from both units and reset from