User's Manual

frequency may prevent correct signal transmission

or reception.

4. Neighbors using electrical devices operating on the

915MHz-signal frequency can also cause

interference.

Note:

When the 915MHz signal is received correctly, do not re-

open the battery cover of either the transmitter or weather

station, as the batteries may spring free from the contacts

and force a false reset. Should this happen accidentally

then reset all units (see “Setting up” above) otherwise

transmission problems may occur.

The transmission range is around 330 feet (100 meters)

from the thermo-hygro transmitter to the weather station

(in open space). However, this depends on the

surrounding environment and interference levels. If no

reception is possible despite the observation of these

factors, all system units have to be reset (see “Setting

up” above).

POSITIONING THE WEATHER STATION

The weather station provides the option of table standing

or wall mounting the unit. Before wall mounting, please

check that the outdoor data can be received from the

desired locations.

To wall mount:

1. Fix a screw (not supplied) into the

desired wall, leaving the head

extended out by about 5mm.

2. Place the weather station onto

the screw, using the hanging hole

on the backside. Gently pull the

weather station down to lock the

screw into place.

Foldout table stand:

The foldout table stand leg is located

on the backside. Pull the stand out

from the bottom center edge of the

weather station, below the battery

compartment. Once the foldout table

stand is extended, place the weather

station in an appropriate location.