Installation Guide

Sensor Weather Shield

Model: 925-1418

DC: 021318

The Sensor Weather Shield is designed to protect your outdoor sensors from rain and snow.

This shield will oer limited protection from the sun’s heat.

• Temperature sensor

• Temperature/Humidity sensor

• Probe sensor

PAGE 1
Sensor Weather Shield The Sensor Weather Shield is designed to protect your outdoor sensors from rain and snow. This shield will offer limited protection from the sun’s heat.
PAGE 2
Holes for mounting screws Sensor Velcro Tape Slots for zip ties Upright Base Holes for mounting screws If you have a sensor with a probe wire, there is a hole for the probe to exit. Note: Sensor and probe are not included INSERT SENSOR (not included) • • • • • Twist the cover clockwise to remove the base. Attach the Velcro tape to the sensor and to the upright on the base. This keeps the sensor from tipping. Alternately, secure the sensor with a zip tie.