FAQ

La Crosse Technology, Ltd. Page 7
Complete a Manual Tip Test and a Water Tip Test and compare them:
Manual Tip test: Write down the Total Rain reading or reset the Rain Total to 0.00.
Use the eraser end of a pencil to manually tip the rocker of the rain sensor 10 times
(five each way). Wait at least 2 minutes for all the rain to collect.
Water Tip Test: Write down the Total Rain reading or reset the Rain Total to 0.00.
With Rain Sensor mounted slowly pour water into the funnel to tip the rocker of the
rain sensor 10 times (five each way). Wait at least 2 minutes for all the rain to
collect.
 Compare these tests. If they still read high then contact support.
Rain shows zeros
Zeros indicate the Indoor Station and rain sensor are connected.
 Check that the pin the rocker tips on is all the way to the back and that the
rocker tips freely.
 Check that there is no cardboard below the rocker. This should be removed after
unboxing.
 Check that the funnel is positioned over the rocker. They are offset due to the
antenna.
 Check the funnel and the inside of the rain sensor for insect nests or debris that
may cause loss of rocker motion.
 Check for proper battery installation.
 Check the battery compartment is on firmly and squarely on the station.
 Mount the rain sensor level and check that the mounting screws are not too
tight (most common issue).
 Use the eraser end of a pencil to manually tip the rocker of the rain sensor 10
times (five each way).
 Wait at least 2 minutes for all the rain to collect.
 Check the Total Rain on the Indoor Station for a reading.
 Complete a factory restart.
Rain shows dashes
Dashes indicate the Indoor Station and rain sensor are not connected.
 Check that the battery cover is securely on the rain gauge.
 Distance/Resistance can cause loss of sensor signal. This rain gauge reads
directly to the display. Try moving the rain gauge closer to the display.
 Check batteries in the rain sensor and the Indoor Station. This is our primary
warranty issue.
 Orient the Indoor Station 90 degrees towards the rain sensor for better
reception.
 Complete a factory restart.
Outdoor Temperature
Dashes shown for Outdoor Temperature
 Dashes means the connection is lost between the rain station and the outdoor
sensor.
 Check the reading on the sensor display.