Manualshelf

Installation Guide

ManualsBrandsLa Crosse Technology ManualsClocksWiFi Projection Alarm Clock with Outdoor Temperature and Humidity and Remote Home Monitoring
12345678910
02
Initial Setup
Power Up
Note: It may take up to 10 minutes for your sensor data to appear on your Alarm
Clock’s screen.
BASICS
Back of Alarm Clock
Thermo-Hygro
Sensor
Alarm Clock
Insert the 5V Power Adapter into an outlet, and then plug it into the Power Jack on the back
of the Alarm Clock. Next, remove the Insulation Tab from the Battery Compartment located on
the bottom of the Alarm Clock.
Thermo-Hygro (TH) Sensor
Install 2 fresh “AA” batteries according to polarity and replace battery cover. The blue LED light will
flash when transmitting.