FAQ
Table Of Contents
- 616-1410 & 616-12667FAQS
- CONTENTS
- BATTERIES: What do I need to know about batteries?
- HARDWARE: Sensors and Clock
- What are the power requirements for this clock?
- SETUP: How do I setup my clocks?
- MOUNTING: Where do I mount/position my sensor?
- Where to I place my clock?
- TIME: Does this clock have Atomic Time?
- How do I manually set the time?
- How Many Time Zones are available?
- What are the Daylight Saving Time (DST) Settings?
- WEEKDAY: How do I correct the day of the week?
- Does this clock have 12 hour and 24 hour time options?
- Does this clock have a backlight?
- WHAT IS Auto Dim backlight?
- Where did my calendar go?
- How do I set my Time alarm?
- What are my Projection Options?
- Can I change the brightness of the projection?
- Can I change the Orientation of the Projection?
- Why doesn’t the temperature/humidity readings on my clock match the Weather report?
- What does a reading of “HI” or “LO” mean?
- What does “NO” mean?
- Why does my Temperature readings come and go?
- What is Distance | Resistance | Interference?
- Can I change batteries in my sensors without losing data?
- FACTORY RESET: How do I factory reset my clock?
9 | Page
Activate/Deactivate Alarm:
• The alarm is active when set.
• Press the ALARM button to deactivate or activate the alarm. The alarm time will show for 2
seconds.
• Alarm icon (bell) will show then active.
Snooze:
• When alarm sounds, press the SNOOZE/LIGHT button to silence alarm for 10 minutes.
• The Snooze Icon Zz will flash.
• Press any button except SNOOZE/LIGHT to silence the alarm for 24 hours.
• When alarm ends by button press or time out after 2 minutes, GOOD DAY will show for 2
seconds then return to normal time display.
WHAT ARE MY PROJECTION OPTIONS?
Projection Options: INDOOR TEMP OUTDOOR TEMP TIME
• Time only
• Indoor Temp only
• Alternate Time + Indoor Temp
Change Projection Options:
1. Hold the PROJECTION button to enter Projection Settings.
2. Use the PLUS or MINUS button to change projection selection (each selection will show for 2
seconds).
3. Projection image will stay on last option selected.
CAN I CHANGE THE BRIGHTNESS OF THE PROJECTION?
• Press the PROJECTION button to change the brightness (HI-LO-OFF).
CAN I CHANGE THE ORIENTATION OF THE PROJECTION?
• Move the Projection Arm backward or forward to project on the wall or ceiling.
• Use the Rotation Wheel on the back of the projection arm to change the projection orientation
270 degrees.