FAQ
Table Of Contents
- 616-1410 & 616-12667FAQS
- CONTENTS
- BATTERIES: What do I need to know about batteries?
- HARDWARE: Sensors and Clock
- What are the power requirements for this clock?
- SETUP: How do I setup my clocks?
- MOUNTING: Where do I mount/position my sensor?
- Where to I place my clock?
- TIME: Does this clock have Atomic Time?
- How do I manually set the time?
- How Many Time Zones are available?
- What are the Daylight Saving Time (DST) Settings?
- WEEKDAY: How do I correct the day of the week?
- Does this clock have 12 hour and 24 hour time options?
- Does this clock have a backlight?
- WHAT IS Auto Dim backlight?
- Where did my calendar go?
- How do I set my Time alarm?
- What are my Projection Options?
- Can I change the brightness of the projection?
- Can I change the Orientation of the Projection?
- Why doesn’t the temperature/humidity readings on my clock match the Weather report?
- What does a reading of “HI” or “LO” mean?
- What does “NO” mean?
- Why does my Temperature readings come and go?
- What is Distance | Resistance | Interference?
- Can I change batteries in my sensors without losing data?
- FACTORY RESET: How do I factory reset my clock?
8 | Page
2. Press the + or – buttons to turn dimmer (ON). AUTO DIM ON will show.
3. Press the SNOOZE/LIGHT button to select start time (Hour) for dimmer. START TIME and the
hour will flash.
4. Press the + or – buttons to change the hour for the dimmer to be low light level.
5. Press the SNOOZE/LIGHT button to select start time for dimmer to be on High light level.
STOP TIME and the hour will flash.
6. Press the + or – buttons to change the hour for the dimmer to be high light level.
7. Press the SNOOZE/LIGHT button to confirm exit.
While Auto Dim is active:
• Press and release the SNOOZE/LIGHT button to adjust the backlight for 10 seconds. Intensity
Levels: 0FF | 1.5% | 20% | 50% | 100%.
• If you change the backlight setting the clock will stay on the new setting and will
automatically go back to the auto dim on the next start point.
WHERE DID MY CALENDAR GO?
Press and release the CALENDAR button to change the Calendar and view Alarm time. Your
clock will stay on your selection.
Calendar Options:
o Full Weekday
o THU 10/29
o Alarm Time
HOW DO I SET MY TIME ALARM?
Set Alarm:
1. Hold the ALARM button to enter settings mode.
2. Press the + or - button to adjust the flashing values.
3. Hold the + or - buttons to adjust quickly.
4. Press the ALARM button to confirm adjustments and move to the next item.
5. Press the SNOOZE button at any time to exit.
Note:
1. If no buttons are pressed in a 10 second period, set mode will time out and return to live
display mode, reflecting whatever adjustments were made by user before timed out
2. Alarm is crescendo sound. When the alarm sounds, it continues for 2 minute and then shuts
off completely.
Important:
• When Alarm is set, the Alarm Time will automatically show.
• Press the CALENDAR button to view the Calendar instead of Alarm Time.