FAQ
Table Of Contents
- 616-1410 & 616-12667FAQS
- CONTENTS
- BATTERIES: What do I need to know about batteries?
- HARDWARE: Sensors and Clock
- What are the power requirements for this clock?
- SETUP: How do I setup my clocks?
- MOUNTING: Where do I mount/position my sensor?
- Where to I place my clock?
- TIME: Does this clock have Atomic Time?
- How do I manually set the time?
- How Many Time Zones are available?
- What are the Daylight Saving Time (DST) Settings?
- WEEKDAY: How do I correct the day of the week?
- Does this clock have 12 hour and 24 hour time options?
- Does this clock have a backlight?
- WHAT IS Auto Dim backlight?
- Where did my calendar go?
- How do I set my Time alarm?
- What are my Projection Options?
- Can I change the brightness of the projection?
- Can I change the Orientation of the Projection?
- Why doesn’t the temperature/humidity readings on my clock match the Weather report?
- What does a reading of “HI” or “LO” mean?
- What does “NO” mean?
- Why does my Temperature readings come and go?
- What is Distance | Resistance | Interference?
- Can I change batteries in my sensors without losing data?
- FACTORY RESET: How do I factory reset my clock?
4 | Page
4. CALENDAR button
Normal Time Display-
• Press to change Calendar Mode
o THURSDAY
o THU 10/29
o Alarm Time
5. -(MINUS) button:
Setting-
• Press to decrease values during setting.
• Hold 2 seconds to quickly adjust values.
6. SET button:
Normal Time Display-
• Hold for 2 seconds to enter Settings Menu
• Press to search for Atomic Time Signal
Settings Menu:
• Press and release to confirm setting and move to next item or exit
7. +(PLUS) button:
Normal Time Display-
• Hold to search for outdoor sensor.
Settings-
• Press to increase the values by one.
• Hold 2 seconds to quickly adjust values.
8. ROTATE wheel
Normal Time Display-
• Spin to rotate projection image
TIME: DOES THIS CLOCK HAVE ATOMIC TIME?
•
The clock will search for the atomic signal at power up and at UTC 7:00, 8:00, 9:00, 10:00,
and 11:00.
•
If there is no WWVB reception, the clock will search for the atomic time signal every 2 hours
until the WWVB time is received.
•
The atomic time signal icon will flash while searching. The tower icon will be solid when it
has connected.