FAQ
Table Of Contents
- 616-1410 & 616-12667FAQS
- CONTENTS
- BATTERIES: What do I need to know about batteries?
- HARDWARE: Sensors and Clock
- What are the power requirements for this clock?
- SETUP: How do I setup my clocks?
- MOUNTING: Where do I mount/position my sensor?
- Where to I place my clock?
- TIME: Does this clock have Atomic Time?
- How do I manually set the time?
- How Many Time Zones are available?
- What are the Daylight Saving Time (DST) Settings?
- WEEKDAY: How do I correct the day of the week?
- Does this clock have 12 hour and 24 hour time options?
- Does this clock have a backlight?
- WHAT IS Auto Dim backlight?
- Where did my calendar go?
- How do I set my Time alarm?
- What are my Projection Options?
- Can I change the brightness of the projection?
- Can I change the Orientation of the Projection?
- Why doesn’t the temperature/humidity readings on my clock match the Weather report?
- What does a reading of “HI” or “LO” mean?
- What does “NO” mean?
- Why does my Temperature readings come and go?
- What is Distance | Resistance | Interference?
- Can I change batteries in my sensors without losing data?
- FACTORY RESET: How do I factory reset my clock?
3 | Page
• For accurate humidity readings, avoid placement near vegetation and lakes or other bodies
of water when possible.
• Maximum transmission distance from your thermos-hygro sensor to your clock, in open air is
330 feet (100 meters).
• Insert the mounting screw through the front of the transmitter and into the wall. Tighten the
screw to snug (do not over tighten).
WHERE TO I PLACE MY CLOCK?
• Your clock is designed for flexible placement on a desk or countertop.
• Position within reach of an outlet that is always active. Some outlets in living rooms and in
bedrooms may only be active when the light switch is on.
• Best reception occurs when only one wall is between your clock and each sensor outside.
• Position you clock six feet from other electronics and wireless devices. If you suspect RF
(radio frequency) interference, simply move your clock a few feet.
BUTTON FUNCTIONS
There are 7 function buttons on this clock.
1. SNOOZE/SNOOZE/LIGHT button
Normal Time Display-
o Press to adjust backlight 5 levels (OFF, 1, 2, 3, 4)
o Hold to select Auto Dim settings.
Alarm Sounds-
o Press to snooze alarm for 10 minutes
Settings-
o Press to exit any setting menu
2. PROJECTION button
Normal Time Display-
o Press to change projection intensity (HI, LOW, OFF)
o Hold to change what is projected
3. ALARM button
Normal Time Display-
o Press to activate/deactivate time alarm
o Hold to set alarm time