FAQ
Table Of Contents
- 616-1410 & 616-12667FAQS
- CONTENTS
- BATTERIES: What do I need to know about batteries?
- HARDWARE: Sensors and Clock
- What are the power requirements for this clock?
- SETUP: How do I setup my clocks?
- MOUNTING: Where do I mount/position my sensor?
- Where to I place my clock?
- TIME: Does this clock have Atomic Time?
- How do I manually set the time?
- How Many Time Zones are available?
- What are the Daylight Saving Time (DST) Settings?
- WEEKDAY: How do I correct the day of the week?
- Does this clock have 12 hour and 24 hour time options?
- Does this clock have a backlight?
- WHAT IS Auto Dim backlight?
- Where did my calendar go?
- How do I set my Time alarm?
- What are my Projection Options?
- Can I change the brightness of the projection?
- Can I change the Orientation of the Projection?
- Why doesn’t the temperature/humidity readings on my clock match the Weather report?
- What does a reading of “HI” or “LO” mean?
- What does “NO” mean?
- Why does my Temperature readings come and go?
- What is Distance | Resistance | Interference?
- Can I change batteries in my sensors without losing data?
- FACTORY RESET: How do I factory reset my clock?
12 | Page
FACTORY RESET: HOW DO I FACTORY RESET MY CLOCK?
For best results please bring the outdoor sensor in the house and place 5 feet from the display
unit.
1. Remove batteries from the sensor and batteries (and/or a/c cord) from the display.
2. With the power removed, press one of the buttons on the display at least 20 times to clear
all memory. Please do this even if the display is blank to remove any random electricity.
Verify the display is blank.
3. Please be sure you are using fresh batteries testing to a minimum of 1.48, on a voltmeter that
reads in numbers. Place batteries into the outdoor sensor first. Make sure they are installed
according to the diagrams in the battery compartment.
4. Install batteries (or a/c cord) into the clock according to the diagram in the battery
compartment.
5. Allow the sensor and display to remain 5 feet apart for 15 minutes to establish a strong
connection. Do not press buttons during this time. You should see a reading on the outdoor
temperature area in the first minute.