FAQ

La Crosse Technology, Ltd Page 5
Replacement Remote sensors
• Visit your local Retailer or La Crosse Technology® Store
https://www.lacrossetechnology.com/support/?type=parts
• Note: Be sure to order the correct model and frequency to avoid receiving the
incorrect item.
• Call La Crosse Technology® Store at 608-785-7939 or e-mail from the store website if
you are unsure about the correct item to order. Each item carries the original new
product warranty and includes access to La Crosse Technology® technical support.
Mounting/Positioning Remote sensor
First: Place the remote sensor in the desired shaded location and the atomic clock in the
home. Wait approximately 1 hour before permanently mounting the remote sensor to
ensure that there is proper reception.
POSITION
Outdoor:
• Protect the remote sensor from standing rain or snow and from the overhead sun,
which can cause it to read incorrectly.
• Mounting under an eave or deck rail works well.
• If you choose, you can construct a small roof or box for the remote sensor. Be sure a
box has vents.
• Mount the remote sensor on the North side where to prevent sun from causing
incorrect readings.
• Mount at least 6 feet in the air for a strong RF (radio frequency) signal.
• Do not mount the remote sensor on a metal fence. This significantly reduces the
effective range.
• Remote sensors are water resistant, not waterproof.
Indoor or Outdoor:
• Mount remote temperature sensor vertically.
• Avoid more than one wall between the remote sensor and the atomic clock.
• The maximum transmitting range in open air is over 200 feet (60 meters).
• Obstacles such as walls, windows, stucco, concrete and large metal objects can
reduce the range.
• Do not mount near electrical wires, transmitting antennas or other items that will
interfere with the signal.
• RF (radio frequency) signals do not travel well through moisture or dirt.
MOUNT
Option 1:
• Install one mounting screw (not included) into a wall.
• Place the remote sensor onto the screw (hanging hole on the backside).
• Gently pull down to lock the screw in place.
Option 2:
• Insert the mounting screw through the front of the remote sensor and into the wall.