User Manual

Atomic Time Signal

Setup

1. Insert 2 “AA” batteries into the

clock according to polarity

markings.

2. Manually Set Time/Date

Note: The clock will search for

atomic time 2 hours after

batteries are installed.

Settings: Language, Time, Date, etc.

• Hold the MODE button to enter time set mode.

• Press the + or - buttons to adjust the values.

• Press the MODE button to conrm adjustments and move to the

next item.

• Press the SNOOZE button at any time to exit.

Setting mode order:

1. Language (English or Spanish)

2. Beep ON/OFF

3. Atomic ON/OFF

4. Time Zone

5. DST ON/OFF

6. 12/24 Hour

7. Hour

8. Minutes

9. Year

10.Month

11.Date

12.Fahrenheit/Celsius

Page | 2 www.lacrossetechnology.com/support 513-1419-WA

• This clock while plugged in, may take up to 3 days to get the signal.

• The clock will automatically search at UTC 7:00, 8:00, 9:00, 10:00,

and 11:00.

• If there is no WWVB reception, the clock will search for the atomic

time signal every 2 hours until the WWVB time is received.

• After reception, this clock will only search for the atomic signal

after midnight.

• To perform a manual search for the atomic time signal, hold the

MINUS button for 3 seconds. The atomic time icon will ash.

• For information about WWVB atomic time signal visit: