FAQ
Table Of Contents
- 513-05867 FAQS
- CONTENTS
- BATTERIES: What do I need to know about batteries?
- What are the power requirements for this clock?
- SETUP: How do I setup my clock?
- How do I manually set the time?
- Does this clock have 12 hour and 24 hour time options?
- What do the Daylight Saving Time (DST) Settings mean?
- How do I select Fahrennheit or Celsius?
- TIME: Does this clock have Atomic Time?
- What is Desired Hour (Time Adjust) and how do I set it?
- Can I change the Calender Display?
- How do I select where Time and Temperature are Display?
- Can I add sensors?
- What does a reading of “HI” or “LO” mean?
- What does “NO” mean?
- FACTORY RESET: How do I factory reset my clock?
6 | Page
• If your temperature is fine but your humidity is reading “HI” or “LO” or dashes, your humidity
may be below 10% Relative Humidity. Your sensor does not read below 10% humidity.
WHAT DOES “NO” MEAN?
• If a sensor loses connection to the station for any reason, the station will show NO after 30
minutes.
• The station will search for 3 minutes every hour to reconnect with sensor.
• Hold the + (PLUS) button to search for the sensors in the Outdoor Area
• Icon will flash while searching for sensor. Outdoor area will show dashes during the
search. When sensor is received the icon will be solid.
• If no sensor received, icon disappears after 3 minutes of searching if sensor is not
found.
• NO will again show in the outdoor sensor area.
FACTORY RESET: HOW DO I FACTORY RESET MY CLOCK?
To factory reset your clock:
1. Remove batteries and press any button 20 times.
2. Reinsert batteries.