22” Indoor | Outdoor Atomic Wall Clock Model: 404-3556A DC: 122816 www.lacrossetechnology.
Get Started 1. Remove round battery cover to access clock movement and battery compartment(s). 2. Insert 1 AA battery into the movement at the center of the clock. 3. OPTIONAL: For extended battery life, install two additional batteries, one on either side of the movement. 4. Select your specific time zone by firmly pressing the correct time zone button once. Replace battery cover. 5. The default time zone is Pacific Time.
Manual Set Time On rare occasions in certain areas, the clock may not be able to receive the radio controlled time signal due to the strength of the signal or the geographic location. In this case, the clock can be set manually and used as a regular quartz wall clock. 3 Battery Compartments Time Set Tab Daylight Saving Time Indicator Time Zone Buttons Note: Allow up to five nights for the clock to receive the WWVB signal before manually setting the time. Set the clock manually: 1.
Temperature and Humidity The La Crosse Technology® atomic wall clock has two analog sensors that measure surrounding temperature and humidity. The temperature information is displayed in degrees Fahrenheit and Celsius, and humidity data is displayed in percentage. Humidity display in % Inner ring displays temperature in degrees Celsius Outer ring displays temperature in degrees Fahrenheit The thermometer and hygrometer have been calibrated at the factory.
Atomic Time Signal For information about WWVB, atomic time signal visit: http://bit.ly/AtomicTime Signal Interference In some cases, the signal is affected by weather conditions and electrical interferences, or the location of the clock itself may result in poor reception. If the clock has not synchronized to the correct time within a few days of activation, you may need to move the clock to a different location. Visit Us on Social Media http://bit.ly/LaxTech_YouTube http://bit.
• • Remove batteries from equipment that is not to be used for an extended period of time. Promptly remove expired batteries. Specifications Battery Requirements: 1 AA (IEC LR6) required in movement (Alkaline recommended) Optional: 2 additional AA (IEC LR6) batteries for extended battery life. Battery life: 1 battery; over 12 months 3 batteries; over 36 months Warranty and Support Information La Crosse Technology, Ltd.
