Application Guide

Troubleshooting steps
o  DISTANCE: Bring the transmitter and Weather Station together inside and
place both 5-10 feet apart with nothing between them.  REMOVE POWER:
Remove batteries and a/c cord from transmitter and Weather
Station. DISCHARGE ELECTRICITY: Press one of the buttons on the
Weather Station at least 20 times to clear all memory. Verify that the Weather
Station is blank before proceeding.  UNPOWERED 10 MINUTES: Let the
Weather Station and transmitter sit with power removed for at least 10
minutes.  WEATHER STATION: Insert 5-volt A/C power cord or install fresh
alkaline batteries in the Weather Station.  TRANSMITTER: Insert fresh
batteries into the transmitter, observing the correct polarity.  PRESS TX
BUTTON: Press the TX button on the back of remote Transmitter to transmit
RF (radio frequency) signal. Keep the transmitter 5-10 feet from the Weather
Station.  WAIT: Wait for 5 minutes for the outdoor temperature/humidity to
appear.  CONNECTION: When RF (radio frequency) connection is
established, the respective temperature & humidity will appear on the main unit.
Allow the transmitter and Weather Station to sit together for 15 minutes to
establish a strong connection.  PLACE TRANSMITTER OUTSIDE: For
optimum 433MHz transmission, place the outdoor transmitter a distance of no
more than 200 feet (60 meters, open air) from the Weather station.