User Guide
Table Of Contents
- 1. Important safety information
- 2. Range overview
- 3. Oven cooking guide
- 4. Cleaning your range
- 5. Troubleshooting
- 6. Installation Instructions
- 7. Service and parts
- 8. Installation safety instructions
- 9. Installation
- 11. Gas connection
- 12. Conversion to LP Gas
- 13. Electrical connection
- 14. Final fitting and checks
- 15. Circuit diagram
- 16. Technical data
- 17. Warranty
35
INSTALLATION
Check the appliance is electrically safe when you have nished.
Recommended electrical outlet location
When connecting using a NEMA 14-50R receptacle, if possible
position it so it can be accessed through the opening at the
rear of the drawer cavity (Fig. 13.1). Alternate location within
the shaded area in (Fig. 13.2). The distance between the back
of the range and the wall is approximately 4” (10.6 cm).
Plug the range power cord into a properly grounded wall
receptacle.
DISCONNECT THE ELECTRICAL SUPPLY.
Connecting if the supplied cord and
plug is not suitable.
To remove the electrical connection cover, rst remove the
screws on the top and bottom edges. The cover has two side
and one bottom location tags (Fig. 13.3).
Slide the cover down to free the side tags (Fig. 13.4).
On retting, ensure the cover is correctly located on the tab
on the bottom ange.
8”
12”
12”
12”
Fig. 13.1
Opening inside the drawer cavity
from the oor with range at lowest setting
from the side of the range
Electrical
connection
cover
Fig. 13.2
Fig. 13.3
Fig. 13.4










