Liquid Propane Conversion Guide

SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
4
Valve Adjustment
Pulloallthecontrolknobs.
Openbothovendoorsandremovethexingscrews
underneath the control panel.
Onsingleovenmodelsthecoolingguide,belowthecontrol
panel, and it’s 4 xing screws must be removed to gain
access to the control panel xings.
Remove the 3 xing screws at the top of the control panel.
Pullthecontrolpanelforward.Takingcarenottodamageit,
by protecting it with cloth for example, rest it on the open
oven doors.
To convert the control valves
Turn the bypass screw on each control clockwise to the stop
ArtNo.0102-0011 - Screwing
the control valve bypass screw
The valves in this Range are tted with adjustable bypass
screws. The Range is supplied with the bypass screws set for
Naturalgas.ForLPGconversionthebypassscrewsmustbe
screwed all the way down.
Reassemble
Replace the control panel and secure with xing screws.
Ret the control panel and cooling guide where tted
If you have lifted the maintop, carefully lower it onto the
range. The burners are protected against the burner ames
goingoutbyFlamesafetydevices(FSD’s).
TakecarewhenloweringthemaintoptolocatetheFSD
sensorprobes(arrowedbelow)intheirholesinthecooktop
and the burner bases.
ArtNo.102-0003 - FSD burner probe
Gas Regulator
Removethestoragedrawer.Pullitouttoitsfurthest
point.
ArtNo.342-0003 - Elan drawer pulled out
ArtNo.342-0002 - Elan - drawer position
Liftuptheendsoftheplasticclips(oneeachside)to
release the catches holding the drawer to the side rails
and at the same time pull the drawer forward and away
from the side rails. For safety’s sake push the drawer rails
back out of the way.
The regulator is now accessible.