Installation & User Guide
Table Of Contents
- 1. Important safety information
- 2. Range overview
- 3. Cooking tips
- 4. Cooking table
- 5. Cleaning your range
- 6. Troubleshooting
- 7. Installation Instructions
- 8. Service and parts
- 9. Installation safety instructions
- 10. Installation
- 11. Gas connection
- 12. Conversion to LP Gas
- 13. Electrical connection
- 14. Final fitting and checks
- 15. Circuit diagram
- 16. Technical data
- 17. Warranty
34
INSTALLATION
Check the appliance is electrically safe when you have nished.
Fitting the drawer
NOTE: To avoid exterior damage to the storage drawer. Place
a soft cushioned mat on the oor.
To t the drawer, refer to “Fitting the drawer”.
Check the appliance is gas sound.
DO NOT use a ame to check for gas leaks.
When using test pressures greater than ½ psi (3. 5 kPa)
to pressure test the gas supply system of the residence,
disconnect the range and individual shut-o valve from the
gas supply piping.
When using test pressures of ½ psi (3. 5 kPa) or less to test
the gas supply system, simply isolate the range from the gas
supply system by closing the individual shut-o valve.
Check the operation of all the burners.