User and Installation Guide

INSTALLATION

Check the appliance is electrically safe when you have nished.

4-Wire Conduit Installation

Disconnect the supplied power cord from the terminal block

and ground post. Keep the terminal block parts; you will need

them. Remove the strain relief clamp from the power cord

and remove the power cord and strain relief clamp from the

mounting bracket (Fig. 13.11).

The range is shipped with reducer plates to give a 1 ⁄’’

diameter opening for conduit connection (Fig. 13.11). Find

the reducer plates (Fig. 13.8) in the conversion kit and t

them to the mounting bracket.

Fit a squeeze connector (not supplied with the range), to your

conduit. Insert the conduit through the reducer plates on the

mounting bracket. Allow enough slack to easily attach the

wires to the terminal block.

NOTE: Do not install the conduit without a squeeze

connector.

Fit the wires to the ground post and terminal block (Fig.

13.12)

NOTE: Make sure the wires are completely inserted into

the terminals and secure connections are made.

Secure the squeeze connector in place in the bracket by

tightening the squeeze connector screws.

Ret the electrical connection cover.

Seal the Openings

Seal any openings in the wall behind the range and in the

oor under the range when hookups are completed.

When all Connections are Completed

MAKE SURE THE FLOW OF COMBUSTION AND

VENTILATION AIR TO THE RANGE IS UNOBSTRUCTED.

Fig. 13.11

Fig. 13.12

Black

Red

White: Neutral

Ground wire