User and Installation Guide
37
INSTALLATION
Check the appliance is electrically safe when you have nished.
Fitting a 3-Wire Power Cord
Disconnect the supplied power cord from the terminal block
and ground post. Keep the terminal block parts; you will need
them. Slacken the strain relief clamp from the power cord,
untighten the 2 screws (Fig. 13.5) and remove the power
cord.
Insert the new power cord through the strain relief device but
do not tighten the device yet.
n
Your range is supplied with a ground strap that
can be used when connecting to a three wire cord.
Consult your electrician before changing the
supplied cord kit (Fig. 12.9).
Fit the Ground strap to the ground and center terminal of the
connector block (Fig. 13.6).
The neutral or ground wire of the power cord must be
connected to the neutral terminal located in the center of the
connector block. The power leads must be connected to the
outside terminals (Fig. 13.6).
Make sure the connections are tight. Now tighten the strain
relief device to clamp the power cord.
Ret the electrical connection cover.
Fig. 13.5
Fig. 13.6
Screws
Ground strap
Ground Post
Black
Red
White: Neutral
Strain relief device