installation user_guide

31
INSTALLATION
Check the appliance is electrically safe when you have nished.
Burner head
Burner Base
Brass Venturi
Burner ring
Rubber tubing
12. Conversion to LP Gas
Fig. 12.1
Fig. 12.2
Fig. 12.3
Important
• Observe all governing codes and ordinances.
• The range must be properly grounded.
• Save these instructions for the local electrical inspector’s
use.
When servicing or replacing gas-carrying components,
disconnect from gas before commencing operation and
check appliance is gas sound after completion. When
checking for gas leaks, use a liquid leak detector at all joints
and connections to check for leaks in the system. Use a
product specically manufactured for leak detection. Leak
testing of the appliance shall be conducted in accordance
with the manufacturer’s instructions.
For your safety
DO NOT store or use combustible materials, gasoline or other
ammable vapors and liquids in the vicinity of this or any
other appliance.
Conversion to Propane
This appliance is supplied set for Natural gas. A conversion
kit for Propane gas is supplied with the range (kit number
A060048).
If the appliance is to be converted, this must be done before
installation. The conversion must be performed by a qualied
LP gas installer. After conversion, the installation must comply
with the relevant regulations and also the local electricity
supply company requirements. Read the instructions before
converting this appliance.
Failure to convert the appliance correctly could invalidate any
warranty or liability claims and lead to prosecution.
This instruction must be used in conjunction with the rest
of the appliance instruction, in particular for information on
Standards, range positioning, connection hose suitability etc.
When servicing or replacing gas-carrying components,
disconnect from gas before commencing operation and
check appliance is gas sound after completion.
DO NOT use reconditioned or unauthorized gas controls.
Orifices
Remove the burner heads. Undo the large brass nuts and
remove the brass venturis and ring, if tted (Fig. 12.1).
Using a long socket wrench, slacken o each of the orices,
no more than one full turn.
Using the rubber tubing provided in the conversion kit, t
over the end of the socket wrench (Fig. 12.2).
Carefully push the open end of the tubing onto the orice
(Fig. 12.3). Unscrew the orice fully and lift clear of the
cooktop.
Burner head
Burner Base
Rubber tubing
Burner Ring
Brass Venturi