User Manual

Marine Systems
Aviation Recorders
Rev. 06
Mar . 16/11
165M0014-10
Page 3--7
3.1.2. Connecting the IEC Data Interface Cable
The AIS Transponder receives data from the ship’s sensors through a data interface
cable which is connected to the back of the transponder through a data port. IMO
regulations require that the ship heading, speed--over --ground (SOG), course--over ---
ground (COG), rate-- of--turn (ROT) and position be transmitted from the AIS. In or-
der to meet these requirements, the L-3 ProTec provides six data channels to a llow
the AIS to be connected to the ships Gyrocompass and DGPS system in accor-
dance with NMEA 0183.
The L3 AIS is shipped with one IEC interface cable P/N 024M0088-01. All IEC/Pilot
communications with the AIS is referenced with the L-3 ProTec considered the
“MASTER” in that transmit data is OUTPUT from the L-3 ProTec, and receive data is
INPUT to the L-3 ProTec. All channels are isolated with individual shielded twisted
pair cables. The IEC connector (J4) is located on the back of the L-3 ProTec. (Refer
to IEC 61993--2 annex D. and NMEA 0183) IEC channels 1, 2 , and 3 are RECEIVE
ONLY sensor inputs. Differential data (RS422) is received on each of these chan-
nels and internally converted to TTL for input to a standard UART. Channels 4, 5,
and 8 are all RS422 interfaces. IEC channels 4 and 5 are TRANSMIT/RECEIVE
channels for AIS data. IEC channel 8 is the AIS long range port.
3.1.2.1 Data Channels
Data enters the Transponder through six available data channels. Three data chan-
nels are low speed unidirectional (4,800 baud) channels suitable for data input to the
transponder. The other three data channels are high speed bidirectional channels
(38,400 baud) which support both input and output to/from the
transponder.
The channels are described below by channel number and type. Suggested uses of
each channel are provided but it is not required that a user define the channels in
this fashion. The internal software in the transponder is able to distinguish the type
of data feeding from each channel provided all data streams subscribe to the IEC
61162 format (NMEA 0183).
Table 3--1. Data Channels
Channel BAUD Type Suggested Use
1 4800 Receive dGPS (COG, SOG, LAT, LON)
2 4800 Receive Rate of Turn
3 4800 Receive Heading (Gyro)
4 38400 T ransmit / Receive PC Application
5 38400 T ransmit / Receive ARPA/ECDIS
8 38400 T ransmit / Receive Long Range Tracking (Dedicated)