User Manual

Marine Systems
Aviation Recorders
Page 4--22
165M1161--00Initial Issue
Aug. 23/10
4.3.12. Set the SART Relay Parameters
The “SART Relay Mode” requires that the “Interval” and “Duration” parameters be
defined. The “Interval” parameter determines how often the message is retransmit-
ted, and the “Duration” parameter sets how long the unit continues to repeat the
message. To establish the SART parameters, enter “b” in the System Configuration
Menu, and Figure 4--17 appears.
Press “I” to increase the interval of minutes between each transmission by 1 minute
each time the key is hit, and decrease it by 1 minute each time “D” is pressed. The
interval can be set between 1 to 10 minutes.
To set how long the unit continues to repeat the message, press “Shift” and “+” to
increase the “Duration” by 1 minute and “--” to decrease the amount by 1 minute.
This range can be set from 3 to 600 minutes. Hit “Enter,” and the “Hit Any Key to
Continue...” message appears. Press any key to return to the System Configuration
Menu.
Figure 4--17. Set SART Relay Mode Parameters