User's Manual

10. Default Program
12:00 A.M.
Sunday
Date is 01/01 2000
No Run Times (zone 01, —:—)
No Start Times (start number 01, —:—)
100% Water Budget
Every day watering schedule
Mode dial is at OFF position
Program dial is on A program
5 second delay between zones (cannot be changed)
11. Circuit Breaker
An electronic poly-switch is incorporated on the interconnect PCB of the
controller. This type of circuit breaker does not require resetting or
replacement by the user.
Troubleshooting/Service
SYMPTOM POSSIBLE CAUSE SOLUTION
No output to zone, pump,master
valve or no AC indicator _ lit
AC disconnected Check AC source, if AC is not
detected
by the controller , the no AC
indicator will be lit _
No AC and blank display No battery or dead battery Replace batteries
LCD is blank No AC and No battery replace batteries
Ribbon cable is disconnected
Ensure ribbon cable is connected at
both ends
M-X appears on the LCD when
trying to run a zone manually
MODE dial is in program position Position the MODE dial in the
AUTO position to run a zone
manually
C-X appears on the LCD when
trying to CYCLE a program
MODE dial is in program position Position the MODE dial in the
AUTO position to CYCLE a program
S-X appears on the LCD when
trying to run a 3 MINUTE TEST
MODE dial is in program position Position the MODE dial in the
AUTO position to run a 3 Minute
test
The controller will not run a 3
MINUTE TEST
No programs in A, B, or C Enter a program with run times for
the zones you need
P with a zone number appears on
LCD
Wires not connected or short in wires
or solenoid. More than 2 solenoids
connected to a zone
Check field wiring, check solenoid,
replace solenoid
ALL 24HR flashing on LCD Greater than 24 hours of run time
programmed
Check zone run times and WATER
BUDGET percentage
Controller is not watering and RAIN
DELAY arrow appears on LCD
RAIN DELAY is programmed into EZ
PRO
Turn dial to RAIN DELAY position
and check number of days on LCD.
Adjust as desired
RADIO CONNECT symbol appears
on LCD
Controller is radio connected to an EZ
Command Programmer
Turning any dial will disconnect
Rain Sensor symbol on Rain sensor is activated or if no rain
sensor installed the jumper is missing
Check to see if jumper is installed if
there is no rain sensor