User's Manual

Range of Radio Signal
Radio signal range is greatest when there is a clear line of sight
between the EZ Pro and the EZ Command. The type and size of structure
that the EZ Pro is located in as well as the local terrain may effect
performance.
Connected Operation
After one minute of use without a dial turn or a button press the EZ
Command will enter a “sleep” mode. This is to extend battery life.
The unit will “wake” once a minute and update the LCD screen.
Pressing any button or turning the dial will also “wake” the EZ
Command.
After 15 minutes of non-use the radio connection will stop and the EZ
Command will turn off. You will need to connect to the EZ Pro again.
Programming and Operating Instructions
While radio connected use the Large dial, SELECT buttons, ADJUST
buttons, A,B,C button and the AUTO, PROG, OFF button on the EZ Command
to program and operate the EZ Pro controller as desired. See the EZ
Pro TM Instruction book for all programming and operating instructions.
Program changes made while radio connected are retained by the EZ Pro.
Disconnecting from the EZ PRO
To disconnect from the EZ Pro press the Radio On/ Off key. The radio
will disconnect and the EZ Command unit will turn off. Once
disconnected the EZ Pro will return to the previous status. Any
program changes made will be saved in the EZ Pro.
Note: A manual zone run, a Cycle, or a 3 Minute Test started by the EZ
Command will continue after the radio is disconnected. The EZ Pro will
return to its previous status after the operation is finished.
Care of the EZ Command
Avoid letting the EZ Command get wet. While it is water-resistant it is
not waterproof. Water inside the unit will damage the circuitry. Do
not drop the EZ Command. This may damage the unit.