User's Manual

Controller ID- Every controller must have a unique ID. This will
prevent a conflict if more than one controller is within range of the
radio signal. Write down the Controller ID for future reference.
Warning: Do not select the same Controller ID for two controllers within 1 mile of each other. Improper
radio operation may result.
Programmer Access Code- Use the same Programmer Code for all of your EZ
Pro controllers and EZ Command Remote Programmers. This Code provides
the security to prevent unwanted radio access.
Reminder: Use the same Programmer Code on all of your EZ Pro controllers and EZ Command
Programmers
Set a Controller ID and Programmer Code on the EZ Pro Controller
Set the Mode dial on the EZ Pro controller to the Program position.
Turn the large dial on the EZ Pro controller to the Radio Setup
position. Use the SELECT +- to move between Controller ID and
Programmer Code. Use the ADJUST +- keys to set these as you choose.
Return the Mode dial to the OFF or Auto position
Pudik show figure 3 from EZ pro instructions here
Connecting by Radio with the EZ Command Remote Programmer
When the EZ Command Remote Programmer is turned on the LCD screen
displays the last Controller ID and Programmer Access Code used. Use
the Select and Adjust +- keys to choose the Controller ID and
Programmer Code to match the controller you wish to connect to. Press
the Radio ON /OFF button to make the connection.
Note: There must be AC power to the EZ Pro in order to make a radio
connection.
Connection Screen
When connected the Radio Connected ( Pudik show symbol)symbol will show
on both the EZ Command unit and on the EZ Pro. The LCD display will
show the time and current status of the EZ Pro. The LCD screen will
display the EZ Pro’s Mode Dial position (Auto, Program, or Off) and
Program Dial position (A, B, or C). If there are any zone problem
messages these will be displayed on the LCD. If there is a Rain Delay
Programmed or the Rain Sensor is activated these will be displayed.
The EZ Command LCD will display all programming or operation commands
exactly as seen on the EZ Pro controller. This instant feedback
assures that the EZ Pro controller retains any changes you make.
While radio connected the EZ Command will temporarily override dial
settings and status of the EZ Pro. All manual and programming
functions of the EZ Pro can be controlled from the EZ Command Remote
Programmer.