User's Manual

system must have a unique ID for proper radio operation. You must remember the 3
digit ID in order to radio connect to this unit. The ID can be reset at any time by
connecting with the telephone cord and choosing "Actuator ID" from the menu.
Step 8) Disconnect the coiled telephone plug from the telephone jack inside the 8030
RPA.
Step 9) Connect the 8040 telephone cord to the telephone jack inside the 8030 RPA.
Step 10) Secure the 8040 RPA Adapter onto the 8030 RPA
Figures 1,2 and 3 go here
* (Energizer TM is the registered trademark of the Eveready Battery Co., Inc.)
COMMUNICATION
The RPA/8040 unit can now communicate with the 8081 Programmer unit. All
programming and manual operations can now be controlled via the 8081 Programmer
radio connection. The range of signal will be between 6 meters installed in ground and
30 meters above ground. Actual performance will depend on terrain and the
installation configuration.
The RPA/8040 unit has 2 levels of security to protect against tampering.
1) You must know the Actuator ID to connect with the unit.
2) The 8081 Programmer has a 4 digit "Programming code" that is set
by the user. This code is automatically input to the PG Multi-Station Actuator when
the Actuator ID was set. If the "Programming code" has been changed you must
connect by telephone cord to the PG Multi-Station Actuator to reset the code.
INFORMATION TO USER (Section 15.21)
The user is cautioned that any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate this
equipment.
FCC ID: NYD8040
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
NELSON WARRANTY