Use r ’s G u i d e
PACK AGE CON TEN TS One M80 pickup with battery installed One pre-wired strapjack assembly One spare battery One 3/32” Allen wrench Two spare 3/4” pole pieces One spare 3/8” pole piece Two self-stick wire clips One manual One warranty card O V E R V I E W A N D C AU T I O N S The M80 will fit guitars with soundholes larger than 3.55”. Make sure that the M80 will fit the guitar properly before installing the strapjack.
S T R A PJ AC K I N S TA L L AT I O N Drill a clean 1/2” hole in the tail-block for the strapjack. Remove dust & debris from inside the guitar. Remove the strap ring, retaining nut and one washer from the end of the jack. Bring the jack through the pre-drilled hole in the tail-block. Using the internal nut, set the proper depth that will allow the entire smaller threaded section to protrude from the instrument (see figure 1).
AC TIV E O R PA SSIVE O PE R ATIO N The M80 offers you the option of either “active” or “passive” settings, essentially giving you two pickups in one (see figure 2). Fig. 2 Active setting - In this setting, the M80 engages a high quality, all-discrete preamp that is specifically tuned to optimize the M80’s performance. With optimal noise cancellation and a higher output level, the active M80 can plug directly into a P.A. or acoustic amplifier without an external preamp.
only two lights are lit, you have about 50 hours of normal playing time left. If only one light is lit, replace the battery (see figure 4). Make sure the “+” sign is facing outwards. Be sure to unplug your instrument cable from the guitar when not in use to maximize battery life. The battery check will work even when there is no cable plugged in. Press down on this tab to remove the battery Battery type: CR2032 3V lithium coin cell Fig.
REGISTER THIS PRODUCT online at www.lrbaggs.
